phase | string | | | | Pending, Ready or Failed. |
ipAddress | string | | | | IPv4 address with prefix length, when the VPC has IPv4. |
ipv6Address | string | | | | IPv6 address with /64 (the address SLAAC would pick). |
macAddress | string | | | | MAC address of the member's L2 device. |
switch | object | | | | |
switch.path | string | | | | |
underlayAddress | string | | | | The member's tunnel address: inside the gateway's tunnel network, or (a station member, spec 0038 section 28) inside the stations' member range fd00:e8::/64. Stable. |
vni | integer | | | | The tunnel network id of the VPC. |
encapsulation | string | | | | vxlan or geneve. |
mtu | integer | | | | Effective overlay MTU. |
gateway | object | | | | |
gateway.endpoint | string | | | | |
gateway.publicKey | string | | | | |
gateway.underlayAddress | string | | | | |
accessPoint | object | | | | Where the member's tunnel ends: the gateway's access point (access station, spec 0040) or, in a VPC without a gateway, the station it is attached to now (spec 0038 section 28). A station's key changes when it is replaced: a member re-reads this and the config when its tunnel stops answering. |
accessPoint.endpoint | string | | | | host:port, UDP: the IPv4 address when the station has one (a member's network may have no IPv6), else the IPv6 one in brackets. |
accessPoint.endpoint6 | string | | | | The station's IPv6 endpoint, [address]:port, when it has one. |
accessPoint.publicKey | string | | | | The station's (or access point's) WireGuard public key. |
accessPoint.peer | string | | | | The GatewayPeer that is the access point (gateway VPCs). |
accessPoint.name | string | | | | The AccessPoint the member is attached to (VPCs without a gateway). |
accessPoint.vtep | string | | | | The tunnel address the member's VXLAN goes to (fd00:e8::1 on every station). |
config | object | | | | |
config.wireguard | string | | | | The tunnel as a wg-quick file without any command: one interface, one peer (the gateway, the access point or the station). The private key is a placeholder; the member makes its own. |
config.wireguardQuick | string | | | | For access station and station members: the same with the VXLAN device and addresses as PostUp lines, for wg-quick on a Linux host. |
config.script | string | | | | The ip commands that make the member's VXLAN or Geneve device and give it its MAC, MTU and addresses on Linux. |
endpointPingMs | number | | | | Average round-trip ping time in milliseconds to the WireGuard endpoint, reported by the member device. |
endpointPingSamples | integer | | | | Number of round-trip ping samples measured by the member device. |
endpointPingAt | string | | | | RFC 3339 UTC timestamp of the last reported endpoint ping. |
firmwareName | string | | | | Name and version of the firmware running on the member device. |
firmwareHash | string | | | | SHA-256 content hash of the firmware image running on the member device. |
firmwareReleasedAt | string | | | | RFC 3339 UTC build/release timestamp of the firmware running on the member device. |
firmwareWrittenAt | string | | | | RFC 3339 UTC timestamp when this firmware was written to the member device. |
temperatureC | number | | | | Internal chip temperature in degrees Celsius reported by the member device. |
systemLoadPercent | number | | | | Rolling system load percentage (0-100) reported by the member device. |
memoryFreeBytes | integer | | | | Free heap memory in bytes reported by the member device. |
memoryUsedBytes | integer | | | | Used heap memory in bytes reported by the member device. |
conditions | list of object | | | | |
conditions[].type | string | | | | |
conditions[].status | string | | | | |
conditions[].reason | string | | | | |
conditions[].message | string | | | | |